| Make | Model | Problem | Solution | Date |
| | | |
| Found: 11
|
| Loewe Opta | 66450 | SLOW TO SWITCH ON | C671 , C673 ( LOW ) | 14-09-04 |
| Loewe Opta | ARTS35 66472 | SOUND MOTORBOATS WHEN COLD | C671 1000uF 16v ALSO C675 | 14-09-04 |
| Loewe Opta | C8000 | WHISTLES + HIGH HT | C638 | 14-09-04 |
| Loewe Opta | C8001 | PICTURE NAOW + TUBE LOOKS POOR HT LOW NOT 142v B | C652 47uF 250v | 14-09-04 |
| Loewe Opta | MS124 | POOR FIELD LIN | C581 47uF 63v | 14-09-04 |
| Loewe Opta | MS56 C8001 | Dead. | LOPT SC , R583 OC 22R , IC1581 SC TDA4950 | 14-09-04 |
| Loewe Opta | MS56 C8001 | DEAD STBY LED LIGHT R534 LINE DRIVER FEED OC | REPLACE R534 3R3 T534 C534 | 14-09-04 |
| Loewe Opta | PROFI S28 C8001 | NO LINE DRIVE | T534 SC USE TIP41 | 14-09-04 |
| Loewe-Opta | ME26/Chassis110C8 | East-West. Excessive width, won't adjust. | Change L573. Seemed to be OK visually. | 14-09-04 |
| Loewe-Opta | ME26/Chassis110C8 | Very int. Field collapse, white line in the center of screen for a few seconds, and then black screen with no sound. | When the problem occurs, make continuity check between pin 12 of the yoke plug and pin6 of vertical IC. If open, fit a piece of wire. | 14-09-04 |
|
|
| Loewe-Opta | ME26/Chassis110C8 | Won't start, goes to Stby. Hor driver T541 Sced, supply resistor R503 oc. After replacement, It was Sced again. | Change C546 0,33uF/250V located in front of the LOPT transistor. Also check/replace C503 22uF cap. | 14-09-04 |